Panel Door with a four 2over2 panel layout it is beaded on both sides of the door
Made from: Pine
Internal use
Finish: Painted White
*We offer a paint/varnish stripping service please get in touch to get a quote if you require this. We can also apply a new finished eg wax*
Used condition
Flaking paint ,Has not be cut square at the top,We have measured to make the door square,Needs a good clean ,Old 1970s panel pin holes around the edge ,Some old lock holes ,Some old nail or screw holes ,Some scratches and marks
Comes with cast iron hinges
As well as the description, we have taken 12 pictures, please look through them in detail.
4th picture shows unusual finger plate low down, could of been from a child’s bedroom?
8th picture shows top not square, height measurement taken on the left of this picture.
10th picture shows old pins in the outside of the door


Measurements:
Height: 190.5cm or 75"
**Height could be cut down by 9cm**
**0cm off the top 9cm off the bottom**
**Which could make the height as low as 181.5cm or 71 3/8 inches**

Width: 70.8cm or 27 3/4"
**Width could be cut by 3cm**
**Which could make it as narrow as 67.8cm or 26 5/8 inches**

Door Thickness: 3.5cm or 1 3/8 inches

**This information is a guide only, the amount that can be cut is from the top or the bottom or both and the same with the sides, it may be possible to cut more but it might effect the strength or look
Also note we measure using CM and then it gets converted to inches & rounded down to the nearest eighth (1/8) of an inch

Approximate Weight: 15kg or 33lbs
Approximate age: Victorian
Victorian era 1837 to 1901