Panel Door with a four horizontal panel layout thumb nail beading both sides
Made from: Pine & ply panels
Internal use
Finish: Painted White
*We offer a paint/varnish stripping service please get in touch to get a quote if you require this. We can also apply a new finished eg wax*
Used condition
Flaking paint ,Has not be cut square at the bottom,Has not be cut square at the top,We have measured to make the door square,Some old lock holes ,Some old nail or screw holes ,Some scratches and marks
No hinges
As well as the description, we have taken 12 pictures, please look through them in detail.
5th picture shows old hook screw holes
8th picture shows top not cut square
9th picture shows bottom not cut square, measurements allow for this to be squared up


Measurements:
Height: 190cm or 74 3/4"
**Height could be cut down by 5cm**
**1cm off the top 4cm off the bottom**
**Which could make the height as low as 185cm or 72 3/4 inches**

Width: 73.7cm or 29"
**Width could be cut by 3cm**
**Which could make it as narrow as 70.7cm or 27 3/4 inches**

Door Thickness: 3.5cm or 1 3/8 inches

**This information is a guide only, the amount that can be cut is from the top or the bottom or both and the same with the sides, it may be possible to cut more but it might effect the strength or look
Also note we measure using CM and then it gets converted to inches & rounded down to the nearest eighth (1/8) of an inch

Approximate Weight: 15kg or 33lbs
Approximate age: 1950s 1960s

No hinges but we may have some old hinges in stock that may suitable for this item, get in touch if you need some.