Panel Door with a four 2over2 panel layout panels are square edged
Made from: Pine
Internal use
Finish: Painted Yellow
*We offer a paint/varnish stripping service please get in touch to get a quote if you require this. We can also apply a new finished eg wax*
Used condition
Flaking paint ,Needs a good clean ,Some old nail or screw holes ,Some scratches and marks ,Would benefit from a sanding
comes with steel hinges
As well as the description, we have taken 12 pictures, please look through them in detail.
4th picture shows height of corner off
5th picture shows width of corner off
6th picture shows dents
7th picture shows this side has flaking paint
12th picture shows steel hinges

Measurements:
Height: 219.4cm or 86 3/8"
**Height could be cut down by 14.5cm**
**3.5cm off the top 11cm off the bottom**
**Which could make the height as low as 204.9cm or 80 5/8 inches**

Width: 80.2cm or 31 1/2"
**Width could be cut by 4cm**
**Which could make it as narrow as 76.2cm or 30 inches**

Door Thickness: 3.2cm or 1 1/4 inches
Redoing the top to make it square but shorter Height (Bottom of the corner taken off): 206.5cm or 81 1/4"

**This information is a guide only, the amount that can be cut is from the top or the bottom or both and the same with the sides, it may be possible to cut more but it might effect the strength or look
Also note we measure using CM and then it gets converted to inches & rounded down to the nearest eighth (1/8) of an inch

Approximate Weight: 20kg or 44lbs
Approximate age: Victorian
Victorian era 1837 to 1901