Panel Door with a four 2over2 panel layout panels are square edged
Made from: Pine
Internal use
Finish: Painted Green and cream
*We offer a paint/varnish stripping service please get in touch to get a quote if you require this. We can also apply a new finished eg wax*
In a rustic condition
Also some light burn marks that should fade with sanding,Flaking paint ,Has not be cut square at the top,We have measured to make the door square,Old 1970s panel pin holes around the edge ,Some old lock holes ,Some old nail or screw holes ,Some scratches and marks
No hinges
As well as the description, we have taken 12 pictures, please look through them in detail.
5th picture shows partly stripped with a blowtorch!


Measurements:
Height: 199cm or 78 1/4"
**Height could be cut down by 9.5cm**
**1.5cm off the top 8cm off the bottom**
**Which could make the height as low as 189.5cm or 74 1/2 inches**

Width: 83.5cm or 32 3/4"
**Width could be cut by 4cm**
**Which could make it as narrow as 79.5cm or 31 1/4 inches**

Door Thickness: 4cm or 1 1/2 inches

**This information is a guide only, the amount that can be cut is from the top or the bottom or both and the same with the sides, it may be possible to cut more but it might effect the strength or look
Also note we measure using CM and then it gets converted to inches & rounded down to the nearest eighth (1/8) of an inch

Approximate Weight: 20kg or 44lbs
Approximate age: Victorian
Victorian era 1837 to 1901
No hinges but we may have some old hinges in stock that may suitable for this item, get in touch if you need some.